Pump type MA is the standard heavy duty slurry pump which designed for the continuous pumping of highly abrasive, high density slurries with minmal maintenance requirements. It maintains components. This type of pump typically used in process plant transfers, wet waste processes, recycling-washing plant, sand plant duties, heavy minerals processing, mineral recovery and chemical process plant.

The MH high head slurry pump is cantilevered, horizontal, centrifugal slurry pump, which is specifically designed to combat the need to run conventional to generate high heads often required in many modern slurry pumping application single pump unit rather than series pumping can be adopted, at greatly reduced capital cost, while still offering optimum wear life and efficiency.

The MG series gravel pumps are designed for continuously handling the most difficult higher abrasive slurries which contain too big solids to be pumped by a common pump. The pumps are suitable for delivering slurries in mining, explosive sludge in metal melting, dredging and so on. Single casing with exceeded passage and lowered NPSHr makes MG pumps as a best selection for dredging, delivering sludge I mining plant.

The heavy duty sump pump MV is designed for applications requiring great reliability and durability. The bearing assembly allows the pump to operate in the “snore” condition without damage to the bearings, it is designed for handling abrasive slurries and corrosive fluids by using either elastomer or alloy lined wet ends components. The pump is suitable for mining, chemical treatment, waste water treatment, gravel and general process application.

Wear Liner for Crusher, Ball mill, Feeding chute and so on. The features of our wear liners are rational design, easy installation,even worn, long service life and etc.

The MA-SUB submersible slurry pump is used submerged totally including motor, the pump is composed of MA pump head and a submersible slurry motor. The feature of the pump is easy to install, convenient operation, suitable for deep pit slurry transfer.

The MD dredge pump is horizontal, single-stage, cantilevered structure which is designed to meet the requirement of the contractor demanding and comprehensive dredging requirement. The pump has excellent wear resistance and high efficiency, easy to maintain and improve the output of the operation. For the pump with discharge from 200mm to 500mm is single casing, and discharge from 600mm to 1000mm is double casing.

The MF series froth pump is typically used to convey abrasive or corrosive frothy slurries. A typical feature of this vertical centrifugal slurry pump is the double-casing design which allows the case to be split open along its centerline. Wet parts are replaceable and made of abrasion resistant high chromium. Depending on your specific pumping task, we can rubber and polyurethane to construct the internal pump liner and impeller.

Pump type ML is the standard light duty slurry pump which designed for the continuous pumping of light abrasive, light density slurries with minimal maintenance requirements. The maintain high efficiencies over the wear life of its components and typical used in process plant transfers, wet waste processes recycling-washing plant, sad plant duties, heav minerals processing, mineral recovery and chemical process plant.